In a hazardous environment, which may lead to personal injury or death, property Identifies information about practices or WARNING circumstances that can cause an explosion The following annotations and their accompanying statements help you to identify a potential hazard, avoid a potential hazard, and recognize the consequences of a potential hazard: Throughout this publication, notes may be used to make you aware of safety considerations. Reproduction of the contents of this copyrighted publication, in whole or part, without written permission of Rockwell Automation, is prohibited. Since there are many variables and requirements associated with any particular installation, Allen-Bradley does not assume responsibility or liability (to include intellectual property liability) for actual use based upon the examples shown in this publication.Īllen-Bradley publication SGI-1.1, Safety Guidelines for the Application, Installation and Maintenance of Solid-State Control (available from your local Allen-Bradley office), describes some important differences between solid-state equipment and electromechanical devices that should be taken into consideration when applying products such as those described in this publication. In no event will Allen-Bradley be responsible or liable for indirect or consequential damage resulting from the use or application of these products.Īny illustrations, charts, sample programs, and layout examples shown in this publication are intended solely for purposes of example. Informations sur l’utilisation de cet équipement en environnements dangereux :īecause of the variety of uses for the products described in this publication, those responsible for the application and use of these products must satisfy themselves that all necessary steps have been taken to assure that each application and use meets all performance and safety requirements, including any applicable laws, regulations, codes and standards.The following information applies when operating this equipment in hazardous locations:.Explicit Message Program Control Limitations.How the Processor and Scanner Module Manage Messages.How to Format the Explicit Message Transaction Block.How the Explicit Message Program Control Feature Works.Configure Your Module for the DeviceNet Network.Use BTR to Upload Input Data from the Scanner. ![]() Using BTW to Send Outputs to the Scanner.How Your Module Communicates with the PLC-5 Processor.Set Node Address Switches for Channels 1 and 2.Set the Data Rate Switches for Channels 1 and 2.Series A Channel, Port and Switch Identification.
0 Comments
Leave a Reply. |